SE205 (Replaces Most 3 & 4 Cylinder Mercury OB)

• Replaces most 3&4 Cylinder 2-Stroke 1987 and newer 70-125 HP
• Also replaces most 75-115 HP 4-Stroke below Serial #OT801000.
• This unit will not replace a 3 jaw lower unit unless you also change the shift shaft in the midsection.
• This unit will only work if you have a 4-1/4 bullet diameter.
• This unit will not replace models with a plastic water pump housing.
• You must verify your Gear Ratio. See Table 1 Below
• 2.31 ratio is no longer available. 2.33 is the proper replacement.
• You must verify your engine type, Two Stroke Carb, DFI (Direct Fuel Injection), or 4-stroke.
• You must verify your shaft length. See Figure 1 below.
• Your model # can also tell you the shaft size. An L is a 20″ and an XL is a 25″. If in doubt, please verify.
• There is also an LL model which is a 22.5 Inch Shaft. We do not offer this shaft size.
• If you have any questions about your application, please email us at [email protected] with your engine serial number

Table 1(Below):

!! Not Eligible For Free Shipping !!